I was trying to install Mozilla Firefox on my laptop. When i try to install it shows me a mesage "install with Administrator account". I try to install with my account which is Administrator of Laptop but still it says "install with Administrator" and I stuck as i haven't use/seen any Administrator account. After that i search on google and came to know that it's hidden and not enable by default, so we have to enable this account on windowns-7 machine. Here we go :)
1. Go to Command Prompt
2. c:\> net user administrator /active:yes
The command completed successfully
3. The above line shows the successfull result.
4. Now you can use your Administrator account.
I hope this will be informative for you.
Cheers :)
Saturday, December 31, 2011
Sunday, December 25, 2011
Huawei Basic Commands
Hi Everyone !
I don't have time to talk about the basic commands of huawei, i will talk about the details stuff of it. If one is use to with cisco so he/she will not face any problem in understanding Huawei. I got this site with having the basic commands for huawei. If you want to study so look at Mariusz Stola
I Hope this wil be informative for you !
Cheers :)
I don't have time to talk about the basic commands of huawei, i will talk about the details stuff of it. If one is use to with cisco so he/she will not face any problem in understanding Huawei. I got this site with having the basic commands for huawei. If you want to study so look at Mariusz Stola
I Hope this wil be informative for you !
Cheers :)
The SERDES Module on Subcard NP-3 1 is Failed
I got this problem in our network on one of our NE40E. Before going to the troubleshooting section, I just need to go through the impact of th above problem on a system. Actually we have three groups of SERDES on NE40E i.e. 0,1 and 2 on the LPU. These SERDES are plot on sub-card 0 and 1. If we have problem on SERDES 0 it will not effet the services on SERDES 1 and like wise.
The problem cause can be identifed by checking the clock of SERDES module. The above problem can result because of:
1. Sub-card-1 not prooperly connected to LPU
2. Sub-card 1 is faulty
3. The Port is not configured correctly
4. The connector between the Sub-card and LPU is faulty
5. The optical module is faulty
Solution
1. We have to check wheather the sub-card ETH_xyz_abc_CARD is registere by using the following command.
display device pic-status
2. If it is registered, then we have to replace our optical module.
3. If Optical module is working normal then plug out from the existing sub-card and plug-in in another card. For Example from Sub-Card 0 to Sub-Card 1.
4. Now again verify by using the above command and collect the trap information.
display trapbuffer
terminal monitor
I hope this will be informative for you.
The problem cause can be identifed by checking the clock of SERDES module. The above problem can result because of:
1. Sub-card-1 not prooperly connected to LPU
2. Sub-card 1 is faulty
3. The Port is not configured correctly
4. The connector between the Sub-card and LPU is faulty
5. The optical module is faulty
Solution
1. We have to check wheather the sub-card ETH_xyz_abc_CARD is registere by using the following command.
2. If it is registered, then we have to replace our optical module.
3. If Optical module is working normal then plug out from the existing sub-card and plug-in in another card. For Example from Sub-Card 0 to Sub-Card 1.
4. Now again verify by using the above command and collect the trap information.
I hope this will be informative for you.
Subscribe to:
Posts (Atom)